COBRA IMMOBILISER

ART.0802

INSTALLATION INSTRUCTIONS

WIRING

WIRE COLOUR	WIRE IDENTIFICATION	CONNECTION
BLACK (1, 5 mm²)	+ 30E	Connect to a permanent positive on the fuse box (+ 30).
BLACK (1, 5 mm²)	+ 15	Connect to an ignition live wire (+ 15)
BLACK (1, 5 mm²)	GND	Connect to a good GND point.
BLACK (1, 5 mm²)	GND	Connect to a good GND point.
BLACK (1, 5 mm²)	1	For the 1st vehicle immobilisation. REQUIRED: Cut an ignition live wire (+ 15).
BLACK (1, 5 mm²)	2	For the 2^nd vehicle immobilisation
BLACK (1, 5 mm²)	BZZ	Negative for Buzzer (Option). To isolate if not used.

AUTO LEARNING (NEW CODING)

Follow this procedure to replace the electronic 'contact ' keys:

Be sure that immobiliser unit is disarmed. Turn the switch n. ° 1 to the "ON" position.
Insert the first electronic key into the control panel plug.
Wait for 1 second.
Insert the second electronic key into the control panel plug. Move the switch n. ° 1 to the "OFF" position.
Check the electronic Keys operation;

IMPORTANT

Identifiy all the black wires BEFORE stripping ends;
After installation is complete there is to be no means df identification of the immobiliser modules wires.
For electric connections it is forbidden to use fast connectors (Scotch Locks). Reychem connectors must be used.
Use two different end points for GND connections.
The system will automatically arm itself after 30 seconds the ignition key has been switched off.

TECHNICAL FEATURES

Operating voltage	9- 15V DC
Current Draw@ 12, 0 V:
System armed:	<7 mA
System disarmed:	<8 mA
Operating temperature for Central Unit	30°C+ 85°C
Immobilisation relays circuits	30 A for 5" 20 A fixe
LED supply capacity	10 mA
Buzzer supply capacity	50 mA
Dimension of Central Control Unit	116 х 35 х 88 mm
Weiaht of Central Control Unit	550 gr.

COBRA IMMOBILISER ART.0802 - схема подключения